Protection Testing with Client/Server Communication (MMS)

Client/Server communication is used for acknowledged point-to-point data transmission in IEC 61850 Digital Substations.
The station control or control center (SCADA, the client) sends a command to the intelligent electronic device (IED, the server). It gets a confirmation or a report back containing status information. Our Test Universe software uses the MMS protocol to obtain feedback from the tested IEDs.

전문가 추천

Protection testing with IEC 61850 SCADA communication

After stimulation with secondary signals or MMS communication, Test Universe determines the reaction of the IED based on its data model and the reports sent to the control center. The device under test is automatically put into test mode and properly reset to normal operation mode afterwards.

Test Universe
PC software suite for advanced secondary testing
자세히 알아보기
CMC 500
Modular, multi-phase protection relay test set and commissioning tool
자세히 알아보기
정보 요청

이 솔루션의 이점

Full IEC 61850 data model access

Test Universe provides you with all available attributes in the data model of the IED. It unveils details which are not included in GOOSE messages or reports.

Verified transmission

Obtaining feedback from reports sent by the IEDs allows you to verify correct signaling to the control center at the same time.

Informative C/S monitor

The C/S monitor provides you with a list of all Client/Server transactions to analyze the communication activities in the network.

Easy configuration

Set up your tests efficiently with System Configuration Language (SCL) data. This speeds up the configuration and avoids errors.

Literature
IEC 61850: Thematic Introduction and Testing Solutions (4 MB)
Test Universe 3.10 Module: IEC 61850 Client/Server Brochure (584 KB)

비디오

OMICRON’s IEC 61850 and Cybersecurity Solutions

더 자세한 정보가 필요합니까?
견적을 받고 싶습니까?
데모를 요청하고 싶으십니까?
지금 연락하십시오
You are using an outdated browser version.
Please upgrade your browser or use another browser to view this page correctly.
×